Supplies: Magnetic board with wooden frame (I got mine from Roberts), scissors, paper, Mod Podge, paint brush, vinyl lettering (opt).
I cut diagonal strips to put along the inner edge. I found 5 12x12 pieces of green pieces of paper to put into place. After cutting a strip out, I used Mod Podge to paste it down as flat as I could.
Here is the board with the paper completely on. I then painted Mod Podge all over the paper and right when it was dry, I placed the face of the board on a flat ground so it would dry flat
I used my Cricut to make a letter to place in the lower right hand corner.
Ta Da!!!
No comments:
Post a Comment
Thank you so much for leaving a comment! I read every single one and thank you for stopping by.